How To Trim A Boat When Making Turns

How To Trim A Boat When Making Turns

Maximize your boats performance and fuel efficiency by learning how to properly use your trim switch.  Boating Magazine has some great instruction on how to trim a boat while making turns.  Adjusting the trim properly is essential to smoother, safer turning.

Trim A Boat Graphic

 “Remember: If the drive is trimmed up, the bow will come up. If the drive is trimmed down, the bow will come down.”  Tim Barker

 

If emails to the editor and anecdotal information from boatbuilders and boat dealers is any indication, a substantial number of boaters express confusion about how to trim their boats’ engines or drives. Certainly this applies to getting on plane, adjusting for load, trimming for ride comfort or to suit sea conditions, and more. Let’s review the basic principles of how to trim an outboard or sterndrive boat through turns.

1. Into the Turn

265SS Turning

While cruising along, you’ll approach the turn with your drive trimmed out (up). This allows you to maintain some speed and ensures the boat begins tracking through the turn on its after sections. You do not want to approach a sharp turn with the trim all the way in (down) because that might cause the bow to dig in, and the boat theoretically could spin out or even swap ends. Instead, begin the turn at cruising trim, and then “ride” the trim switch down as you approach the apex of the turn.

As the boat reaches the apex of the turn, you feel it begin to slow down because you now have a larger portion of the hull length in the water. With the drive trimmed down, the stern is less likely to break out and you can accelerate safely, adding the rpm necessary to regain — or even maintain — speed. The timing of this depends upon the boat (boats with more ­buoyancy in the bow might require less trim) and sea conditions (you’ll be going slower with more negative trim in choppier water).

E285XS Turn

3. Out of the Turn

As you leave the apex of the turn and accelerate onto your new course heading, you’ll do the opposite of what you did in Step No. 1. Ride the trim switch, trimming the drives out (up) while accelerating until you find your cruising speed and trim. Of course, now that you are headed in a different direction, you’ll be hitting waves and running with respect to the wind differently than you were before the turn. Adjust as required; there is no “perfect” amount of trim for a given boat speed.

Read Next: How to Properly Trim a Sterndrive

 

Crownline Boats patented Fast Tab Hulls were made gripping the water.  The performance and design of our hulls reduces the need to adjust the trim as much as other brands.  Learn more about Crownline’s Fast Tab Hull Design Here

2019-02-25T14:14:39+00:00

About the Author: